LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2002 >> Durango Base, 5.9 Z, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Body Control Modules) >> Removal & Installation >> Ignition Switch >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Ignition Switch: Installation

WARNING: This page is about a different car, the 2002 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rotate flag on ignition switch to RUN position. This allows lock cylinder to mesh with switch. With key in lock cylinder, turn lock cylinder to RUN position so retaining pin can be depressed. Install lock cylinder in ignition switch (aligning slot) until retaining pin engages (clicks).
  2. Reconnect ignition switch harness connector. Position switch to column and install mounting screws. Tighten screws to specification. See TORQUE SPECIFICATIONS  . Install tilt lever bracket (if equipped). On models without tilt, install bracket. On all models, tighten screws to specification. See TORQUE SPECIFICATIONS  . To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals