LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1997 >> Caravan Base, 2.4 B >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Body Control Computer Tests >> Chime Test 9B - Chime Inoperative With Turn Signal On
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Chime Test 9B - Chime Inoperative With Turn Signal On

NOTE: Perform CHIME TEST 9A  before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAMS  . Perform TEST VER-1A - VERIFICATION PROCEDURE  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Turn ignition off. Disconnect Body Control Module (BCM). BCM is located with junction block under driver's side instrument panel. See Figure in CHIME TEST 2A. Gain access to junction block/BCM internal 23-pin connector. Go to next step.
  2. Turn ignition on. Operate left turn signal. Using a test light, probe internal connector terminal No. 20. If test light flashes, go to next step. If test light does not flash, replace junction block.
  3. Operate right turn signal. Move test light probe to terminal No. 21. If test light flashes, replace BCM. If test light does not flash, replace junction block.
scientia non olet · About LEMON Manuals