Body Control Module (BCM)

REMOVAL 

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
3. Remove the two lower Body Control Module (BCM) retaining bolts.
   NOTE:

   There are no upper mounting bolts. The BCM clips into the upper portion of the bracket.

   Courtesy of CHRYSLER GROUP, LLC

   1 - BCM

   2 - Retaining Bolts

4. Reposition the BCM until the BCM connectors are visible.
5. Disconnect the wire harness connectors from the BCM.
6. Remove the BCM from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Tighten the mounting bolts securely.