Power Liftgate Module (PLGM): Installation
WARNING: This page is about a different variant/trim than selected.
HORIZONTAL
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Verify that the rear alignment mounting tabs are engaged to the panel.
- Perform the liftgate calibration procedure. Refer to POWER LIFTGATE CALIBRATION .
VERTICAL
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Verify that the alignment mounting tabs are engaged to the panel.
- Tighten the bolts securely.
- Perform the liftgate calibration procedure. Refer to POWER LIFTGATE CALIBRATION .