LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2023 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Electronic Control Modules (Service Information)) >> Module, Power Inverter (PIM) >> Removal And Installation >> Power Inverter Module (PIM) >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Power Inverter Module (PIM): Removal

WARNING: This page is about a different variant/trim than selected.
  1. Move the drivers front seat to the full forward position.
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0188574Courtesy of CHRYSLER GROUP, LLC
    1 - Module Cover
    2 - Fastener
    3 - PIM
  3. Remove the fasteners and module cover to gain access to the Power Inverter Module (PIM).
    GC0188573Courtesy of CHRYSLER GROUP, LLC
    1 - PIM
    2 - Fastener
    3 - Wire Harness Connector
  4. Disconnect the wire harness connector from the PIM.
  5. Remove the fastener from the PIM.
  6. Remove the PIM from the vehicle.
scientia non olet · About LEMON Manuals