Fold Stow Module (FSM): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

The third row fold and stow module is located in the 60 percent seat cushion pan. The following steps should be performed on the 60 percent seat only.

Operate the fold and stow switch and until the seat is fully stowed. If the seat is unable to power stow, use the manual stow option.
NOTE:
The manual stow option can be found in the vehicle Owner's Manual.
Disconnect and isolate the negative battery cable.

Courtesy of CHRYSLER GROUP, LLC

1 - Seat Bottom Panel

2 - Seat

Using a trim stick, release the clips and remove the seat bottom panel.

Courtesy of CHRYSLER GROUP, LLC

1 - Electrical Connections

2 - Stow Module

3 - Tab

Disconnect all electrical connections to the fold and stow module.
Depress the tab while lifting up to remove the fold and stow module from the seat frame bottom.