Module, Anti-Lock Brake System (Abs): Installation

Clean any debris off the mating surfaces of the Hydraulic Control Unit (HCU) and Antilock Brake System (ABS) module.
NOTE:
Do not lubricate the ABS module seal.

Courtesy of CHRYSLER GROUP, LLC
A new seal (1) must be installed to properly seal the ABS module (2); DO NOT REUSE ANY ABS MODULE SEALS .

Courtesy of CHRYSLER GROUP, LLC
Align and install the ABS module (1) to the HCU (2).

Courtesy of CHRYSLER GROUP, LLC
Install and securely tighten the ABS module to HCU mounting fasteners (3).
Connect the Antilock Brake System (ABS) module wire harness connector (5).
Install the washer fluid reservoir. Refer to RESERVOIR, WINDSHIELD WASHER, INSTALLATION .
Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .