LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2022 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, Display Screen (DSM) >> Removal And Installation >> 10.1 Inch Screen >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

10.1 Inch Screen: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0177182Courtesy of CHRYSLER GROUP, LLC
  2. With a suitable tool, remove the radio display trim bezel (1) and disconnect the wire harness connectors.
    GC0200376Courtesy of CHRYSLER GROUP, LLC
  3. Remove the Display Screen Module (DSM) mounting bracket fasteners (1).
  4. Remove the fastener (2) from the lower side of the DSM.
  5. Release the tabs (3) around the perimeter of the DSM (4). Remove the DSM and bracket from the display bezel (5).
    GC0200302Courtesy of CHRYSLER GROUP, LLC
  6. If necessary, remove the fasteners (1) and separate the DSM (3) from the DSM bracket (2).
scientia non olet · About LEMON Manuals