LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2022 >> Pacifica Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, HVAC >> Removal And Installation >> Front >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal And Installation: Front: Installation

WARNING: This page is about a different variant/trim than selected.
NOTE:

Illustration shown with instrument panel removed from view for clarity.

GC0177956Courtesy of CHRYSLER GROUP, LLC
  1. Position the HVAC module to the air inlet housing.
  2. Install and tighten the screws (1) that secure the HVAC module to the air inlet housing.
  3. Connect the wire harness connector (2) to the HVAC module.
  4. Install the passenger side knee blocker air bag. Refer to AIR BAG, KNEE BLOCKER, REMOVAL AND INSTALLATION .
    GC0177997Courtesy of CHRYSLER GROUP, LLC
  5. Install the glove box trim panel and glove box and hush panel (1). Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  7. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals