Module, Radio Frequency (RF Hub): Installation
NOTE:
Replace and Program the module(s) per the RFH, BCM, PCM FOBik and ELV Replacement and Programming Order Guide. Refer to STANDARD PROCEDURE .
- Position into place and install the Remote Frequency Hub (RFH) and retainers (1).
- Connect the wire harness connectors (2).
- If equipped, connect the remote start antenna (3).
- If equipped install the sunshade. Refer to SUNSHADE, REAR WINDOW, INSTALLATION .
- Install the rear shelf cover. Refer to PANEL, REAR SHELF, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:
Program the RFH in accordance with the module replacement and programming guide. Refer to STANDARD PROCEDURE .