Module, Anti-Lock Brake System: Installation

Clean any debris off the mating surfaces of the HCU and ABM.
CAUTION:
When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant.

Courtesy of CHRYSLER GROUP, LLC
New solenoid valve stems seals (1) and (2) must be installed. Do not reuse solenoid valve stem seals.

Courtesy of CHRYSLER GROUP, LLC
Replace the pump/motor connector O-ring (1) if it is not new. Be sure the O-ring is properly seated in the mounting groove (2).

Courtesy of CHRYSLER GROUP, LLC
Align components and install the ABM (1) on the HCU (2).

Courtesy of CHRYSLER GROUP, LLC
Install the four screws (1) attaching the ABM (2) to the HCU. Tighten the mounting screws to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
Install the ICU into the vehicle. Refer to INTEGRATED CONTROL UNIT (ICU), INSTALLATION .