LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2017 >> 200 LX, Eng CD ED6 >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Electronic Control Modules (Service Information)) >> Module, Power Sunroof >> Installation >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Module, Power Sunroof: Installation: Installation

WARNING: This page is about a different car, the 2015 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Do not attempt to move or reposition the sunroof glass panel or drive cables with the sunroof motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.

WARNING:

The Sunroof Motor And Module Initialization procedure must be completed any time a sunroof motor and module unit is replaced with a new component. Failure to perform this procedure may result in damage to the vehicle, to the sunroof or in serious or fatal injuries.

Fig 1: Headliner, Bracket, Module Unit, Screws & Module Connector Receptacle
GC0144390Courtesy of CHRYSLER GROUP, LLC
  1. Position the sunroof motor and module unit (4) close enough to the sunroof frame to access and reconnect the sunroof wire harness connector to the motor and module connector receptacle (3).
  2. Position the motor and module through the headliner bracket opening and onto the sunroof frame.
  3. Install and tighten the three screws (2) that secure the motor and module to the sunroof frame.
  4. Reinstall the headliner (1) to the inner roof panel. Refer to HEADLINER, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  6. Perform the Sunroof Motor And Module Initialization standard procedure. Refer to MOTOR, SUNROOF, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals