Oil Pressure Sensor - Installation

INSTALLATION

WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury Service Precautions






NOTE: Apply Mopar(R) Thread Sealant with PTFE to the sensor threads before installing into the engine block.

1. Install the oil pressure sensor (1).





2. Connect the oil pressure sensor electrical connector (1).
3. Lower the vehicle.
4. Perform the High Voltage Power Up procedure Battery System - High Voltage Power Up