LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2008 >> Crossfire 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Electronic Control Modules - Service Information >> Sentry Key Remote Entry Module >> Removal >> Sentry Key Remote Entry Module
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Sentry Key Remote Entry Module

Fig 1: Identifying SKREEM Harness Connectors
GC0033562Courtesy of CHRYSLER LLC
  1. Disconnect the negative battery cable.
  2. Remove the Instrument Cluster. Refer to REMOVAL .
  3. Disconnect the 2-pin CAN BUS harness connector (1) from the SKREEM module.
  4. Disconnect the 2-pin harness connector for the sentry key antenna ring.
  5. Disconnect the 18-pin harness connector (1) from the SKREEM module.
  6. Press the retaining tabs apart.
  7. Remove the SKREEM module from the base plate.
scientia non olet · About LEMON Manuals