October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Checking Vehicle Level
- Observe the general information on chassis alignment inspection. See STANDARD PROCEDURE .
- Inspect the vehicle level at the front axle by performing the following:
- Insert measuring device between the retaining bolts of the lower control arm bearing.
- Position the contact arm of measuring device on the control arm and read off the plumb value of vehicle level, viewed from the center of the vehicle. See STANDARD PROCEDURE .
- Inspect the vehicle level at the rear axle by performing the following:
- Loosen right rear frame brace and swivel to one side.
- Position contact arm on the rear axle shaft and read off the plumb value of the vehicle level, viewed from the center of the vehicle. See STANDARD PROCEDURE .
NOTE:
If the vehicle level is within specification, no further action is required.
- Install adjustable rubber spring mounts, as needed, and rotate the mounts until the vehicle level is within specification.