LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2007 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Vehicle Theft Security System (Service Information)) >> Intrusion Sensor - Export >> Removal >> Transmitter
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Intrusion Sensor - Export: Removal: Transmitter

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Bezel
GC0040904Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. If replacing the bezel, pull the bezel (1) inboard from the C-pillar (3), or use a trim stick or equivalent to unsnap it from the transducer housing (2) of the intrusion sensor transmitter.
  3. Remove the C-pillar trim panel (Refer to BODY/INTERIOR/C-PILLAR TRIM - REMOVAL) .
  4. Remove the two retaining screws from the C-pillar and remove the sensor.
scientia non olet · About LEMON Manuals