LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Battery System) >> Battery >> Installation >> Auxiliary Battery Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Auxiliary Battery Installation

WARNING: This page is about a different car, the 2006 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the battery onto the battery tray. Ensure that the battery positive and negative terminal posts are correctly positioned. The battery cable terminal clamps must reach the correct battery terminal post without stretching the cables.
  2. Reinstall the battery hold downs onto the battery (Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY HOLDDOWN - INSTALLATION) .
    CAUTION: Be certain that the battery cable terminal clamps are connected to the correct battery terminal posts. Reverse battery polarity may damage electrical components of the vehicle.
  3. Reconnect the battery positive cable terminal clamp to the battery positive terminal post. Tighten the terminal clamp pinch-bolt hex nut to 11.8 N.m (105 in. lbs.).
  4. Reconnect the battery negative cable terminal clamp to the battery negative terminal post. Tighten the terminal clamp pinch-bolt hex nut to 7.9 N.m (70 in. lbs.).
  5. Apply a thin coating of petroleum jelly or chassis grease to the exposed surfaces of the battery cable terminal clamps and the battery terminal posts.
  6. Install the top cover on the seat base assembly.
  7. Install the passenger front seat assembly. Refer to INTERIOR/EXTERIOR for procedure.
scientia non olet · About LEMON Manuals