Positive - Battery To Bulkhead: Notes

Fig 1: Battery Positive Cable

Courtesy of DAIMLERCHRYSLER CORP.

Position the battery positive cable in the vehicle taking care to route the cable under the floor cross members.

Fig 2: Bulkhead Fastener
Courtesy of DAIMLERCHRYSLER CORP.
Position the bulkhead insulator aside to gain access to the battery positive cable bulkhead fastener.
Install the battery positive cable to bulkhead fastener.
Position the bulkhead insulator back to the normal position.

Fig 3: Routing Clips

Courtesy of DAIMLERCHRYSLER CORP.

One at a time, secure the battery positive cable to the routing clips located in the rear seat area.

Fig 4: Routing Clips
Courtesy of DAIMLERCHRYSLER CORP.
One at a time, secure the battery positive cable to the routing clips located in the rear compartment area.
Position the carpet back to the normal position.
Install the right, B - pillar lower trim panel, (Refer to BODY/INTERIOR/B-PILLAR TRIM - INSTALLATION) .
Install the right, front and rear door sill trim panels.
Install the right, rear seat cushion. Engage retainer loops into cup on floor kick up. Push downward at forward edge at each retainer loop of the rear seat cushion to engage retainers.
Install the right, front seat, (Refer to BODY/SEATS/SEAT - INSTALLATION) .

Fig 5: Power Distribution Center
Courtesy of DAIMLERCHRYSLER CORP.
Install the battery positive cable to rear Power Distribution Center (PDC) fastener (3).

Fig 6: Battery System Components And PDC Cover
Courtesy of DAIMLERCHRYSLER CORP.
Install the PDC cover (5).
Connect the battery positive cable (1).
Connect the battery negative cable (3).
Install the spare tire cover.