LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Occupant Restraint Controller >> Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Occupant Restraint Controller: Installation

  1. Connect ORC connector and ensure that the connector and all locking tabs are engaged.
    CAUTION: USE SUPPLIED NUTS ONLY
  2. Position ORC (arrow pointing forward) in the console floor bracket, replace ground eyelet, and attach the nuts and tighten to 9.6 to 14 N.m (85 to 125 in. lbs.) torque. See Figure.
    NOTE: Place the ground eyelet over the front (towards the front of the vehicle) weld stud when reattaching the ORC.
  3. Install center console assembly.
    WARNING: DO NOT CONNECT BATTERY NEGATIVE CABLE YET (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TESTING - AIRBAG SYSTEM) .
  4. Close hood.
  5. Verify vehicle and system operation.
scientia non olet · About LEMON Manuals