October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Steering Column Control Module: Disassembly
Courtesy of DAIMLERCHRYSLER CORP.
- Remove the three clockspring screws (1).
Courtesy of DAIMLERCHRYSLER CORP.
- Carefully pull straight up on clockspring to remove. (Refer to RESTRAINTS - SERVICE INFORMATION
).
NOTE:
After the clockspring is removed, there is only one more screw on the top side of the SCCM that needs to be removed and is located at approximately the six o'clock position on the SCCM. It holds the lower side of the steering angle sensor, the lower side of the electric tilt lever assembly, or the strengthening strut if not equipped with electric tilt.
Courtesy of DAIMLERCHRYSLER CORP.
- If equipped with ESP
, remove the steering angle sensor screw located at the six o'clock position on the SCCM and remove the steering angle sensor (1) from the SCCM (2). If not equipped with ESP
, there will be a plastic insert there for strengthening of the SCCM that will lift right out.
Courtesy of DAIMLERCHRYSLER CORP.
- If equipped with manual telescoping column
, remove the strut screw, located at the six o'clock position, and strut (1).
Courtesy of DAIMLERCHRYSLER CORP.
- If equipped with electronic telescoping column
, remove the one remaining screw (4) to electric tilt located at the six o'clock position, and remove stalk and switch (3).
Courtesy of DAIMLERCHRYSLER CORP.
- Remove the speed control switch (1).
Courtesy of DAIMLERCHRYSLER CORP.
- Remove the steering column tilt/telescoping lever (3) screw (4) located at the six o'clock position.
Courtesy of DAIMLERCHRYSLER CORP.
- Remove the three screws (1) from the bottom of the SCCM for the multi-function switch and SCCM circuit board.
Courtesy of DAIMLERCHRYSLER CORP.
- Separate the multi-function switch from the SCCM circuit board.