LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2004 >> Intrepid SXT >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Wiper Module >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Wiper Module: Removal

  1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
  2. Remove driver and passenger side wiper arms. Refer to WIPER ARMS  .
  3. Remove nine screws to cowl screen panel. Refer to COWL GRILLE AND SCREEN .
  4. Remove wiper module mounting bolt located on top of the tower to tower beam.
  5. Remove eight bolts to Tower to Tower (crosscar) support (Fig 1 )..
    Fig 1: Tower To Tower Support Removal
    G03498197Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove three retaining bolts to windshield wiper module (Fig 2 ).
    Fig 2: Wiper Module Retaining Bolts
    G03498198Courtesy of DAIMLERCHRYSLER CORP.
  7. Lift wiper module away from vehicle body.
  8. Disconnect one wire connector.
  9. Remove windshield wiper module from vehicle.
  10. If replacing module, transfer wiper module grommets to new module assembly (Fig 3 ).
    Fig 3: Wiper Frame Grommets
    G03498199Courtesy of DAIMLERCHRYSLER CORP.
  11. Remove one nut to crank arm and remove from motor (Figure ).
  12. Remove three retaining bolts from wiper motor (Figure ).
  13. Remove wiper motor from wiper module assembly. Install onto new wiper module assembly. Refer to WIPER MOTOR  .
scientia non olet · About LEMON Manuals