LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2002 >> Voyager EC >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Fuel Systems >> Fuel System Pressure Release
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Fuel System Pressure Release

WARNING: ALWAYS release fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components.
  1. Remove fuel filler cap. Remove fuel pump relay from Integrated Power Module (IPM). IPM is located on left side of engine compartment, next to battery. See Figure and Figure .
    NOTE: The Intelligent Power Module (IPM) may also be referred to as Integrated Power Module (IPM). In 2000, the IPM was known as the power distribution center.
  2. Start and run engine until it stalls. Attempt to start engine. Continue restarting engine until it will no longer run. Turn ignition off.
  3. Reinstall fuel pump relay in IPM. One or more Diagnostic Trouble Codes (DTC) may set when fuel pump relay is removed. Erase any DTCs that may have set after fuel pressure release procedure.
scientia non olet · About LEMON Manuals