LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Sebring Limited >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Instrument Cluster Systems >> No BCM Bus Messages Received
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

No BCM Bus Messages Received

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Connect scan tool to Data Link Connector (DLC) located under left side of instrument panel. See Figure . Turn ignition on. Using scan tool, attempt to communicate with Body Control Module (BCM). If scan tool communicates with BCM, go to next step. If scan tool does not communicate with BCM, diagnose communication problem. See BUS +/- SIGNALS OPEN OR NO RESPONSE FROM BODY CONTROL MODULE  under COMMUNICATIONS.
  2. Using scan tool, erase DTCS. Cycle ignition off and on and wait about one minute. Using scan tool, check for DTCs. If DTC resets, replace instrument cluster. If DTC does not reset, no problem is indicated at this time. Test is complete.
scientia non olet · About LEMON Manuals