Chime Inoperative At All Times
NOTE:
After making any repairs, perform BODY VERIFICATION TEST
under VERIFICATION TESTS.
- Ensure battery is fully charged. Connect scan tool to Data Link Connector (DLC) located under left side of instrument panel. See Figure . Using scan tool, select BODY CONTROLLER. If scan tool displays NO RESPONSE, go to BATTERY POWER TO MODULE DISCONNECTED under COMMUNICATIONS. If no message is displayed, go to next step.
- Turn ignition on. Using scan tool, activate CHIME TEST. If chime does not sound, replace Body Control Module (BCM). See BODY CONTROL MODULE under REMOVAL & INSTALLATION. If chime sounds, no problem is indicated at this time. Test is complete.