Idle Speed/Throttle Actuator - Electronic: Service and Repair

REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the air plenum.

Idle Air Control Motor:

3. Disconnect the electrical connector.
4. Remove the mounting screws.
5. Remove the IAC.

INSTALLATION
1. Install the IAC to the throttle body.
2. Tighten mounting screws to 3 Nm (25 in. lbs.) torque.
3. Attach electrical connector to the IAC.
4. Install air plenum and tighten the clamp.
5. Connect the negative battery cable.