LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1999 >> Concorde LX, 3.2 J >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Windshield Wiper Test 11A >> Wipers Operate In With Switch In Off Position
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Wipers Operate In With Switch In Off Position

NOTE: Perform WINDSHIELD WIPER TEST 1A  before proceeding with this test. For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST: VER-2A  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Disconnect Body Control Module (BCM) Black 24-pin connector C2. BCM is mounted to junction block located behind left end cap of instrument panel. See Figure.
  2. Disconnect BCM Bone 12-pin connector C3. If wipers stop, replace BCM. If wipers still operate, go to next step.
  3. Disconnect wiper ON/OFF relay from Power Distribution Center (PDC). See Figure. PDC is located in engine compartment. See Figure. If wipers stop, repair Red/White wire (wiper ON/OFF relay control circuit) between ON/OFF relay and terminal No. 4 on BCM Bone 12-pin connector C3 for short to ground. If wipers still operate, repair Red/Yellow wire (wiper HI speed output circuit) or Brown/White wire (wiper LO speed output) between wiper HI/LO relay and wiper motor for short to battery voltage.
scientia non olet · About LEMON Manuals