Shorted Right Front Door Ajar Circuit

NOTE: Perform DOOR AJAR TEST 5A before proceeding with this test. For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST: VER-2A after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.

Disconnect right front door ajar switch connector. Using external ohmmeter, measure resistance between ground and terminal No. 1 (Tan/Red wire) on harness connector. If resistance is less than 5 ohms, repair Tan/Red wire for short to ground. If resistance is 5 ohms or greater, replace right front door latch assembly.