LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1993 >> Imperial >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Servicing - A/T) >> Neutral Safety Switch Adjustments >> Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Neutral Safety Switch Adjustments: Testing

WARNING: This page is about a different car, the 1991 Plymouth Voyager, 1991 Plymouth Grand Voyager, 1991 Dodge Grand Caravan, 1991 Dodge Caravan, and 1991 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. With transaxle linkage properly adjusted, switch should allow starter operation in "P" and "N" only. To test switch, remove wire connector and test for continuity between switch center pin and transaxle case. Continuity should exist only when transaxle is in "P" or "N".
  2. Check for continuity between 2 outer pins. Continuity should exist with transaxle in "R" position only. There should be no continuity between either outside pin and the transaxle case.
  3. To replace neutral safety switch, remove switch from case and allow fluid to drain. Move selector lever to "P" and "N" positions and check that switch operating fingers are centered in switch opening. Install new switch and seal. Tighten to 25 ft. lbs. (34 N.m). Retest switch for continuity and add transaxle fluid as required.
scientia non olet · About LEMON Manuals