Test 9A - Left Rear Door Jamb Switch
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
- Using DRB-II, stop courtesy lights test. Disconnect left rear door jamb switch connector. Check connector condition, and clean or repair connector as necessary.
- Connect jumper wire between terminal No. 2 (Yellow wire) of left rear door jamb switch connector and ground. If courtesy lights are on, replace left rear door jamb switch. Perform VERIFICATION PROCEDURE VER-1. If courtesy lights are off, repair open Yellow wire. Perform VERIFICATION PROCEDURE VER-1.