LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2022 >> Bolt EV >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belts >> Diagnostic Information and Procedures >> DTC B059A >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

NOTE:
  • Refer to: SIR Service Precautions
  • Inspect the terminals of the following components and connectors for damage or corrosion and repair or replace as necessary:
    • P14 Passenger Air Bag Disabled Indicator & Harness Connector
    • K36 Inflatable Restraint Sensing and Diagnostic Module & Harness Connector
  1. Ignition Off
  2. Disconnect the component: P14 Passenger Air Bag Disabled Indicator
  3. Test for less than 10 ohms between the test points: Ground circuit terminal 1 & Ground
    • If 10 ohms or greater 
    1. Ignition Off
    2. Test for less than 2 ohms between the test points: Ground circuit & The other end of the circuit
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Repair the open/high resistance in the ground connection.
    • Go to next step: If less than 10 ohms 
  4. Connect a test lamp between the test points: Control circuit terminal 4 & Ground
  5. Ignition - On / Vehicle - In Service Mode
  6. Perform the scan tool control function: Passenger Seat Belt Reminder Indicator - On and Off
    • If the test lamp is always On 
    1. Ignition Off
    2. Disconnect the electrical connector: K36 Inflatable Restraint Sensing and Diagnostic Module
    3. Ignition - On / Vehicle - In Service Mode
    4. Test for less than 1 V between the test points: Control Circuit & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V - Replace the component: K36 Inflatable Restraint Sensing and Diagnostic Module
    • If the test lamp is always Off 
    1. Disconnect the electrical connector: K36 Inflatable Restraint Sensing and Diagnostic Module
    2. Test for infinite resistance between the test points: Control Circuit & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
    3. Test for less than 2 ohms between the test points: Control Circuit @ Component harness & The other end of the circuit
    4. Test for less than 2 ohms between the test points: Ground @ Component harness & The other end of the circuit
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: K36 Inflatable Restraint Sensing and Diagnostic Module
    • Go to next step: If the test lamp turns On and Off 
  7. Replace the appropriate component: P14 Passenger Air Bag Disabled Indicator
scientia non olet · About LEMON Manuals