Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify the scan tool parameter: Lane Keep Assist Switch Status = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Operate the component: Lane Keep Assist Switch - Press and hold the switch
Verify the scan tool parameter: Lane Keep Assist Switch Status = Active
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Cycle the component from the open position to the closed position: Lane Keep Assist Switch
Verify the component turns On and Off: Lane Keep Assist Switch Indicator
- If the component does not turn On and Off
Refer to: Circuit/System Testing - Test 2
- Go to next step: If the component turns On and Off
- If the component does not turn On and Off
- All OK.