LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Traverse L >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Programming And Setup) >> Repair Instructions >> P16 Instrument Panel Cluster Control Module: Programming and Setup >> Replace and Program ECU (UDV or UHS)
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Replace and Program ECU (UDV or UHS)

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

To program a replacement or an existing ECU, perform the following procedure:

  1. Ignition ON/Vehicle in Service Mode.
    2. NOTE:

    Ensure programming of this module is performed using the EL-52100 (MDI 2). Using the EL-47955 (MDI) will result in a programming failure.

  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. Ignition/Vehicle OFF.
  4. On the SPS Supported Controllers screen, select P16 Instrument Cluster - Graphics Programming and follow the on-screen instructions.
  5. On the SPS Supported Controllers screen, select P16 Instrument Cluster - Programming and follow the on-screen instructions.
  6. On the SPS Supported Controllers screen, select P16 Instrument Cluster - Setup and follow the on-screen instructions.
    7. NOTE:

    If Ethernet programming fails, ensure Instrument Cluster is communicating over ethernet properly. Refer to Scan Tool Does Not Communicate with Vehicle

  8. Clear DTCs.
scientia non olet · About LEMON Manuals