LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2019 >> Volt Premier >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Cooling Systems >> Hybrid/EV System Heating And Cooling >> Repair Instructions >> Drive Motor Control Module Radiator Inlet Hose Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Install the drive motor control module radiator inlet hose to the vehicle.
  2. GM4224581Courtesy of GENERAL MOTORS COMPANY

    Coolant Hose(1) - Install

  3. Clamp(2) - Engage - Hose Clamp Replacement Guidelines - Spring Type
  4. GM4091137Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Check the pump and the bracket for the correct original position.

    Install the generator control module coolant pump bracket (1).

    5. CAUTION:

    Fastener Caution

  5. Install the 2 generator control module coolant pump bracket nuts (2) and tighten to 9 N.m (80 lb in).
  6. GM4091149Courtesy of GENERAL MOTORS COMPANY

    Clip(1) - Install[2x]

  7. Coolant Hose(2) - Install
  8. GM4091148Courtesy of GENERAL MOTORS COMPANY

    Coolant Hose(2) - Install

  9. Clamp(1) - Engage - Hose Clamp Replacement Guidelines - Spring Type
  10. Front Headlamp Replacement - Install
  11. Front Wheelhouse Liner Replacement (Left Side)Front Wheelhouse Liner Replacement (Right Side) - Install
  12. Lower the vehicle.
  13. Fill the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling 
scientia non olet · About LEMON Manuals