LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2019 >> Cruze L >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Cooling System) >> Repair Instructions >> Radiator Mounting Stud Repair >> Repair Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Repair Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pressure test the cooling system. Refer to Cooling System Leak Testing (CO2 Testing) Cooling System Leak Testing (Pressure Test) . If the radiator is not leaky, perform the following procedure.
  2. Remove the radiator. Refer to Radiator Replacement (1.6L Diesel LH7 with Manual Transmission) Radiator Replacement (1.6L Diesel LH7 with Automatic Transmission) Radiator Replacement (1.4L LE2) .
  3. GM2028254

    Grind the fracture surface (1) with a proper tool.

  4. Drill a hole in the center of the fractured surface, using a 6 mm (0.24 in) drill.
  5. GM2028256

    Install the new radiator mounting pin (2).

    1. Install the nut (3).
      2. NOTE:

      The bolt should not be longer than 35 mm (1.38 in).

    2. Install the radiator mounting pin (2) with the bolt (1).
    6. CAUTION:

    Refer to Fastener Caution .

  6. Tighten the bolt 5 N.m (44 lb in).
  7. Install the radiator. Refer to Radiator Replacement (1.6L Diesel LH7 with Manual Transmission) Radiator Replacement (1.6L Diesel LH7 with Automatic Transmission) Radiator Replacement (1.4L LE2) .
scientia non olet · About LEMON Manuals