LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2018 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> Electrical >> Charging Systems >> 12 V Starting And Charging System >> Repair Instructions >> Battery Positive Cable Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. GM4091512

    If the battery positive cable will not be replaced, check the grommet (1) for damage. If the grommet is damaged, replace the grommet, see next steps.

    1. Release the retainer (2) and open the clip (3). Then remove.
    2. Liberally lubricate the grommet and the cable to slide grommet over the over the positive cable terminal.
    3. Liberally lubricate the NEW grommet and the cable to slide grommet over the over the positive cable terminal.
    4. Install the clip to the positive cable and lock the retainer.
    5. Remove the silicon spray or soap water from the positive cable.
  2. GM4087971

    Pull the complete battery positive cable through the body until the grommet locks into the original position.

  3. GM4087970

    Install 3 wire tie retainers (1, 2) on the rear left body in front of the rear axle.

  4. GM4087972

    Battery Positive Cable - Install

    5. CAUTION:

    Fastener Caution

  5. Install the 6 battery positive cable retainer nuts (1) and tighten to 9 N.m (80 lb in).
  6. GM4087967

    Retainer(1) - Install[3x]

  7. GM4087966
    NOTE:

    For a better access, install the wire tie through the wheelhouse.

    Install a new zip tie to the plastic nut and secure the battery positive battery cable.

  8. Lower the vehicle.
  9. GM4091419

    Check the distance (a) 255 mm (10 in) of the battery positive cable.

  10. GM4087969

    Check the 6 retainers (1) of the battery positive cable (2) for proper seat.

  11. Install the battery positive cable bolt (3) and tighten to 15 N.m (11 lb ft).
  12. GM4087968

    Install the cover (3).

  13. Lock the 3 retainers (4, 5).
  14. Install the cover (2).
  15. Lock the 10 retainers (1).
  16. Radio Rear Compartment Speaker - Remove - Radio Rear Compartment Speaker Replacement
  17. Rear Compartment Floor Panel Trim - Install
  18. GM4087965

    Install the battery positive cable bolt (1) and tighten to 15 N.m (11 lb ft).

  19. GM4091417

    Install the battery positive distribution cover (1).

  20. Lock the 2 retainers (2).
  21. Battery Negative Cable Disconnection and Connection  - Connect
scientia non olet · About LEMON Manuals