LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2015 >> Tahoe SSV >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Negative Cable Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Dual Battery) Battery Negative Cable Disconnection and Connection (Single Battery) .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Battery Negative Cable Engine Block Fastener
    GM3637047Courtesy of GENERAL MOTORS COMPANY
  3. Remove the battery negative cable engine block fastener (1) and remove the battery negative cable (2) from the engine.
  4. Detach the battery negative cable from the frame.
  5. Lower the vehicle.
    6. Fig 2: Battery Negative Cable Ground Fastener And Detach Retainers
    GM3249496Courtesy of GENERAL MOTORS COMPANY
  6. Remove the battery negative cable ground fastener (1) and detach the retainers (2) securing the negative battery cable (3) to the lower plenum panel and wheelhouse liner.
    7. Fig 3: Battery Negative Cable Retainer And Battery Current Sensor
    GM2964359Courtesy of GENERAL MOTORS COMPANY
  7. Remove the battery negative cable retainer (1) from the lower front plenum panel and disconnect the engine harness connector (2) from the battery current sensor (4).
    8. Fig 4: Battery Current Sensor And Battery Tray
    GM2964360Courtesy of GENERAL MOTORS COMPANY
  8. Disconnect the battery current sensor (1) from the battery tray and remove the battery negative cable (2) from the engine compartment.
  9. Transfer the battery current sensor, if necessary.
scientia non olet · About LEMON Manuals