LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Trax LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement (with KL9) >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different car, the 2016 Chevrolet Trax and 2016 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Negative Cable And Negative Cable Frame Ground Fastener
    GM4098013Courtesy of GENERAL MOTORS COMPANY
  1. Battery Negative Cable (2) - Install
    2. CAUTION:

    Refer to Fastener Caution .

  2. Battery Negative Cable Frame Ground Fastener (1) - Install and tighten 11 N.m (97 lb in)
  3. Install the battery tray. Battery Tray Replacement 
    4. Fig 2: Battery Negative Cable
    GM4098029Courtesy of GENERAL MOTORS COMPANY
  4. Battery Negative Cable (2) - Install
  5. Battery Negative Cable Nut (3) - Install and tighten 11 N.m (97 lb in)
    6. Fig 3: Battery Sensor Electrical Connector
    GM4098026Courtesy of GENERAL MOTORS COMPANY
  6. Connect the electrical connector.(1)
    7. NOTE:

    Inform the customer that the Stop/Start feature will not be available until the vehicle is allowed to sit for at least 3 hours undisturbed. If diagnosing a stop/start complaint, conduct the battery sensor module learn procedure to verify the repair.

  7. Perform a re-learn procedure on the battery sensor module, refer to Battery Sensor Module Learn 
scientia non olet · About LEMON Manuals