LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> Starter Solenoid Does Not Click >> Circuit/System Verification
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Verification

  1. Ignition ON, observe the scan tool PNP Switch parameter while shifting the transmission. The reading should change between Park/Neutral and In Gear.
  2. Transmission in park, attempt to start the vehicle. The starter relay should click and the engine should begin cranking.
    • If the crank relay does not click or the engine does not crank, refer to Circuit/System Testing  - CRNK Relay Malfunction.
  3. Ignition ON, observe the scan tool ECM Crankshaft Position Sensor Active Counter is not incrementing.
    • If the Crankshaft Position Sensor Active Counter is incrementing, replace the Crankshaft Position Sensor.
scientia non olet · About LEMON Manuals