LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility Wagon, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake >> Installation Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Installation Procedure

  1. Install the CMP sensor (3) and bolt.
    Fig 1: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

  2. Connect the engine wiring harness electrical connector (8) to the bank 2 intake CMP sensor (7).
    Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860429Courtesy of GENERAL MOTORS COMPANY
  3. Position and install the power steering fluid reservoir bracket (2).
    Fig 3: Identifying Remote Power Steering Fluid Reservoir, Bracket & Bolts
    GM1856014Courtesy of GENERAL MOTORS COMPANY
  4. Install the power steering fluid reservoir bracket bolts (1).

    Tighten 

    Tighten the bolts to 9 N.m (8 lb in).

  5. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement .
  6. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
scientia non olet · About LEMON Manuals