LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 367 (Rear Suspension System) >> Repair Instructions >> Support Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Suspension Components
    GM156917Courtesy of GENERAL MOTORS CORP.
  1. Position the rear suspension support in place.
    2. NOTE: Refer to Fastener Notice .
  2. Install the rear wheel spindle rod-to-rear suspension support bolts and nuts.

    Tighten:  Tighten the nuts to 135 N.m (100 lb ft).

  3. Install the rear suspension support mounting bolts.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

  4. Position the rear wheel spindle rod to the knuckle.
  5. Install the retaining bolts and nuts to the knuckle.

    Tighten:  Tighten the nut to 150 N.m (111 lb ft).

  6. Install the stabilizer shaft to the rear suspension support. Refer to Stabilizer Shaft Replacement .
  7. Connect the brake lines to the rear suspension support. Refer to Rear Brake Hose Replacement .
  8. Install the parking brake cables and the tensioner. Refer to Parking Brake Rear Cable Replacement (Z7U) .
  9. Install the exhaust pipe. Refer to Muffler Replacement (Dual Outlet) or Muffler Replacement (Single Outlet) .
  10. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
  12. Adjust the rear wheel alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals