LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 351 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Ball Joint Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Lower Ball Joint
    GM385752Courtesy of GENERAL MOTORS CORP.
  1. Position the new ball joint in the lower control arm.
    2. Fig 2: Installing Ball Stud Nuts & Bolts
    GM385756Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install the NEW ball joint bolts facing downward.
  2. Install the NEW ball joint bolts.
    3. NOTE: Refer to Fastener Notice .
  3. Install the NEW ball joint retaining nuts.

    Tighten:  Tighten the ball joint nuts to 68 N.m (50 lb ft).

  4. Install the lower control arm. Refer to Lower Control Arm Replacement .
  5. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
  6. Remove the support and lower the vehicle. Refer to Lifting and Jacking the Vehicle
scientia non olet · About LEMON Manuals