LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.4L LUV - DTC P0010 To DTC P0315 >> Diagnostic Information and Procedures >> DTC P00E9 >> Circuit/System Verification
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Circuit/System Verification

  1. Ignition ON.
  2. Verify that DTC DTC P0641, P0651, P0697, or P06A3 is not set.
    • If none of the DTCs are set 
    3. NOTE:

    To minimize the effects of residual engine heat and sensor internal heating elements, perform Steps 3 and 4 of this verification procedure only if the ignition has been OFF for 8 hours or more.

  3. Ignition ON.
  4. Verify the following scan tool parameters are within 25°C (45°F) of each other.
    • Start-Up IAT Sensor 1
    • IAT Sensor 2
    • IAT Sensor 3
    • If not within 25°C (45°F) 

      Refer to Circuit/System Testing below.

    • If within 25°C (45°F) 
  5. Engine idling, verify the IAT Sensor 3 scan tool parameter is between: -38 and +128°C (-36 and +262°F).
    • If not between: -38 and +128°C (-36 and +262°F) 

      Refer to Circuit System Testing below.

    • If between: -38 and +128°C (-36 and +262°F) 
  6. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
  7. Verify the DTC does not set.
    • If the DTC does set 

      Refer to Circuit/System Testing below.

    • If the DTC does not set 
  8. All OK
scientia non olet · About LEMON Manuals