Engine Block - Front/Rear Views
WARNING: This page is about a different variant/trim than selected.
Engine Block - Front/Rear Views
| Hole Location | Thread Size | Drill | Counter Bore Tool | Stop Collar | Tap | Driver | Insert | Drill Depth (Maximum) | Tap Depth (Minimum) | ||
|---|---|---|---|---|---|---|---|---|---|---|---|
| - | - | J 42385- | MM | (IN) | MM | (IN) | |||||
| 1 | M8 x 1.25 | 206 | 207 | N/A | 208 | 209 | 210 | 22.5 | (0.885) | 17.5 | (0.688) |
| 2 | M10 x 1.5 | 211 | 212 | N/A | 213 | 214 | 215 | 27.5 | (1.08) | 22.0 | (0.866) |
| 3 | M10 x 1.5 | 211 | 212 | N/A | 213 | 214 | 215 | Through | Through | ||
| 4 | M8 x 1.25 | 206 | 207 | N/A | 208 | 209 | 210 | Through | Through | ||
| 5 | M10 x 1.5 | 211 | 212 | N/A | 213 | 214 | 215 | 25.0 | (0.984) | 19.5 | (0.767) |
| 6 | M10 x 1.5 | 211 | 212 | N/A | 213 | 214 | 215 | 32.5 | (1.279) | 25.0 | (0.984) |
| 7 | M10 x 1.5 | 211 | 212 | N/A | 213 | 214 | 215 | Through | Through | ||
| Bolt hole 6 is drilled and tapped for aluminum block applications only. | |||||||||||