LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Malibu LS, 2.4 U >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Body Control Module Programming and Setup >> BCM Programming
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

BCM Programming

NOTE: Use extreme care when verifying both the VIN and Odometer reading that is set in the service BCM. Once the VIN and Odometer are set in the replacement BCM it is impossible to change them, and if there is a mismatch, the part will be rendered useless.

To setup a new replacement BCM select Vehicle Control Systems, then select the applicable options, then select Module Setup, then select Body Control Module on the scan tool. If the scan tool can communicate with the BCM that is being replaced, select BCM Copy and Flash. If the scan tool is unable to communicate with the BCM that is being replaced, select BCM Setup. After the setup procedure it is necessary to perform the Remote Start setup procedure. Refer to the Notes below for further information.

If the BCM fails to accept the program, perform the following steps:

scientia non olet · About LEMON Manuals