LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Impala LT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.5L - DTC P0341 Through DTC P2544 >> DTC P0641 or P0651 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

NOTE: Additional DTCs will set when disconnecting the components.
  1. Ignition OFF, disconnect the harness connector of all appropriate sensors for the applicable DTC. Refer to Diagnostic Aids for the appropriate sensors.
  2. Ignition ON, measure for 4.8-5.2 V between one of the 5 V reference circuits and ground.
    • If less than the specified range, test for a short to ground on the 5 V reference circuit for each affected component. If all circuits test normal, replace the K20 ECM.
    • If greater than the specified range, test for a short to voltage on the 5 V reference circuit for each affected component. If all circuits test normal, replace the K20 ECM.
    3. NOTE: A short to voltage on the signal circuit of certain components may cause this DTC to set.
  3. Connect each component associated with the 5 V reference circuit, one at a time, while monitoring the appropriate scan tool 5 V Reference Voltage parameter. Verify the voltage remains between 4.8-5.2 V.
    • If not within the specified range when a component is connected, test the signal circuit for a short to voltage. If the circuit tests normal, replace the appropriate component.
scientia non olet · About LEMON Manuals