LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Impala LT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.5L - DTC P0010 Through DTC P0340 >> DTC P0010 >> Component Testing >> Dynamic Test
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Dynamic Test

  1. Ignition OFF, remove the Camshaft Position Actuator Magnet.
    2. NOTE:
    • The Camshaft Position Actuator Magnet pintle should be facing downward for this test.
    • Do not allow electrical current to flow through the Camshaft Position Actuator Magnet for greater than 1-2 s.
  2. Install a 20 A fused jumper wire between the control circuit terminal 1 and B+. Momentarily install a jumper wire between the low reference terminal 2 and ground. The pintle should extend.
    • If the function does not perform as specified, replace the Camshaft Position Actuator Magnet.
scientia non olet · About LEMON Manuals