LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Cutaway 6.6 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Lighting System) >> Repair Instructions >> Cargo Lamp Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Cargo Lamp
    GM820739Courtesy of GENERAL MOTORS CORP.
  1. Install the light assembly into the vehicle with double sided tape.
    2. IMPORTANT: In order to insure a good replacement of new adhesive or of old adhesive, verify that the surface meets the following conditions:
    • The temperature of the surface is approximately 24-41°C (80-105°F).
    • The surface is clean.
    • The surface is free of wax or of oily film.
  2. Connect the electrical connector.
scientia non olet · About LEMON Manuals