LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Cruze LS, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Diagnostic Information and Procedures >> DTC B2455: Cellular Phone Microphone Circuit >> Circuit/System Testing
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the B24 cellular phone microphone.
  2. Ignition OFF and scan tool disconnected, wait until all retained accessory power is OFF, test for less than 10 Ω between the low reference circuit terminal 1 or A (depending on vehicle) and ground, allowing up to 5 minutes for the circuit resistance to drop to its lowest reading.
    • If greater than the specified range, test the circuit for an open/high resistance.
  3. Ignition ON, test for 9.5-10.5 V between the signal circuit terminal 2 or B (depending on vehicle) and ground.
    • If less than the specified range, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K73 telematics communication interface control module.
    • If greater than the specified range, test the circuit for a short to voltage. If the circuit tests normal, replace the K73 telematics communication interface control module.
  4. If all circuit test normal, replace the B24 cellular phone microphone.