LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Corvette Z06 >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Pulley Replacement (LS3, LS7) >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

    Fig 1: View Of Power Steering Pump Pulley Installer
    GM643361Courtesy of GENERAL MOTORS CORP.
  1. Use the J 25033-C:  installer to install the power steering pump pulley.
    2. Fig 2: Measuring Axial Tolerance Of Power Steering Pulley On Pump
    GM254752Courtesy of GENERAL MOTORS CORP.
    NOTE: The power steering pump pulley must be installed onto the power steering pump shaft so that the hub of the pulley is flush to within 0.25 mm (0.010 in) with the end of the pump shaft.
  2. Check the position of the power steering pump pulley on the power steering pump.
  3. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory (w/o LS9) .
  4. Install the BPMV bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement .
scientia non olet · About LEMON Manuals