Specifications Index
CANYON & COLORADO SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT SYSTEM SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 191 lb ft (260 N.m) | ||
| Battery | BATTERY USAGE | ||
| Brakes | |||
| Bleeding Sequence | RR-LR-RF-LF. HYDRAULIC BRAKE SYSTEM BLEEDING (PRESSURE) | ||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drum Brakes | |||
| Service Specifications | DRUM BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERATOR USAGE | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | Serpentine drive belts are not adjustable | ||
| Drive Belt Routing | 2.9L See illustrations under DRIVE BELT REPLACEMENT 3.7L See illustrations under DRIVE BELT REPLACEMENT 5.3L See illustrations under DRIVE BELT REPLACEMENT - ACCESSORY or AIR CONDITIONING COMPRESSOR BELT REPLACEMENT |
||
| Engine Cooling | |||
| General Service Specifications | NA | ||
| Radiator Cap Pressure | Specification is stamped on pressure cap | ||
| Thermostat R & I | |||
| 2.9L & 3.7L | ENGINE COOLANT THERMOSTAT REPLACEMENT (LLV/LLR) | ||
| 5.3L | ENGINE COOLANT THERMOSTAT REPLACEMENT (LH9) | ||
| Water Pump R & I | |||
| 2.9L & 3.7L | WATER PUMP REPLACEMENT (LLV,/LLR) | ||
| 5.3L | WATER PUMP REPLACEMENT (LH9) | ||
| Engine Mechanical | |||
| 2.9L | |||
| Compression | A normal reading should be approximately 215 psi (1482 kPa) The lowest reading should not be less than 70 percent of the highest reading. ENGINE COMPRESSION TEST |
||
| Oil Pressure | Minimum 12 psi (85 kPa) @ 1200 RPM | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| 3.7L | |||
| Compression | A normal reading should be approximately 215 psi (1482 kPa) The lowest reading should not be less than 70 percent of the highest reading. ENGINE COMPRESSION TEST |
||
| Oil Pressure | Minimum 12 psi (85 kPa) @ 1200 RPM | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| 5.3L | |||
| Compression | No cylinder should read less than 100 psi (690 kPa) No cylinder should be less than 70 percent of the highest cylinder ENGINE COMPRESSION TEST |
||
| Oil pressure | 6 psig (41 kPa) at 1,000 engine RPM 18 psig (124 kPa) at 2,000 engine RPM 24 psig (165 kPa) at 4,000 engine RPM |
||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive PlateTorque | |||
| 2.9L & 3.7L | |||
| first pass | 30 ft. lbs. (40 N.m) | ||
| final pass | + an additional 45 degrees | ||
| 5.3L | |||
| first pass | 15 ft. lbs. (20 N.m) | ||
| second pass | 37 ft. lbs. (50 N.m) | ||
| final pass | 74 ft. lbs. (100 N.m) | ||
| Fuel System | |||
| Pressure Specification | 2.9L & 3.7L commanded on with scan tool 50-62 psi (345-427 kPa) 5.3L commanded on with scan tool 50-60 psi (345-414 kPa) |
||
| Fuel Pressure Test Procedure | 2.9L FUEL SYSTEM DIAGNOSIS 3.7L FUEL SYSTEM DIAGNOSIS 5.3L FUEL SYSTEM DIAGNOSIS |
||
| Fuel Filter Location | 2.9L & 3.7L The fuel filter is contained in the fuel tank module inside the fuel tank 5.3L The fuel filter is contained in the fuel sender (pump module) assembly inside the fuel tank |
||
| Fuel Filter R & I | 2.9L FUEL TANK MODULE REPLACEMENT 3.7L FUEL TANK MODULE REPLACEMENT 5.3L FUEL TANK FUEL PUMP MODULE REPLACEMENT |
||
| Ignition | |||
| Firing Order & Cylinder Identification | |||
| 2.9L, 3.7L & 5.3L | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | 2.9L Coil on plug 3.7L Coil on plug 5.3L 397-1,337 ohms |
||
| Ignition Wires (Routing) | |||
| 2.9L | Coil on plug | ||
| 3.7L | Coil on plug | ||
| 5.3L | Spark plugs wires route directly down from coil to spark plug | ||
| Spark Plug | |||
| 2.9L (Type NA) | |||
| Gap | 0.042 in (1.08 mm) | ||
| Torque | 13 lb ft (18 N.m) | ||
| 3.7L (Type NA) | |||
| Gap | 0.040 in (1.016 mm) | ||
| Torque | 13 lb ft (18 N.m) | ||
| 5.3L (NA) | |||
| Gap | 0.040 in (1.02 mm) | ||
| Torque | 11 lb ft (15 N.m) | ||
| Starting | |||
| Starter | NA | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque (See Tightening Pattern under wheel and tire INSTALLATION PROCEDURE | 100 ft. lbs. (140 N.m) | ||